Picture Me Rollin, Motorcycle Accessory Emporium


$19.95 AUD


This clever little tool makes cable lubrication easy.  Clamp the lubricator around the cable end then plug the aerosol can in the side.  A quick squirt and the job's done!
Lubricating a cable is not very difficult, although it can be a bit messy.  A cable luber is a device that seals over one end of the cable, allowing you to inject lubricant into it under pressure, forcing it through the cable housing and out the other end. There is a stepped rubber housing in the device to accommodate the diameter of both the housing and the cable.  The cable and housing is pushed into one end of the device until the housing stops it from going in any further.  The cable should extend out the other end.  The screw is then turned, tightening the seal both around the housing and the cable protruding from one end.
The straw from a spray can is put in the small hole on the side of the rubber housing and the lubricant is injected into the device.  Properly sealed, it should force lubricant into the housing.  In our experience over the years, it will still leak lubricant from several spots, but enough pressure is built to force lubricant down the housing as well.

Add to Cart:

  • 6 Units in Stock
  • Manufactured by: SHOGAI

Your IP Address is:
Copyright © 2021 Picture Me Rollin.